Computers recognize Wi-Fi networks by their SSIDs, not by the channel they use. However, if you really want to manually select the Wi-Fi channels, use different channels for each access point (if possible). Most modern Wi-Fi access points can choose their Wi-Fi channels automatically and you should usually let them do this. As far as I understand it, on the first generation you need to plug your Ethernet cable into the (only-existing) Ethernet port instead. Note: I’ve only tested this with an AirPort Express Base Station of the second generation. You need to plug your Ethernet cable into the WAN port – not the Ethernet port. It’ll then pick the one that’s best suited (usually the one with the best signal strength). In “Wireless” section, don’t use “Extend a wireless network”! Instead, use “Create a wireless network” and enter the same SSID and Wi-Fi encryption as the network you’re extending.īackground info: If a computer finds multiple Wi-Fi networks with the same SSID, it’ll assume they represent the same network.This is called roaming and has existed since the earliest days of Wi-Fi.įor the AirPort Express Base Station (and maybe other Wi-Fi access points as well) there are three things you need to know: Extending Wi-Fi networks over Ethernet (roaming) ∞įortunately, there is an alternative: extending Wi-Fi networks over Ethernet (cables). While this will probably have no real effect on your surfing speed, the speed of copying files from one computer to another will be drastically reduced. The disadvantage is that this will reduce your wireless bandwidth (by 50% in the worst case). The advantage is that you don’t need any cables to extend the range of your network. So, the AirPort Express Base Station will communicate with your other access point(s) over Wi-Fi. You can also repeat a signal in theoory with out the cable, have not tried that though as it increases lag, halves the speed, and i have an ethernet cable where i want the router.The catch here is, though, that this will extend your Wi-Fi network over Wi-Fi. Setup was easy, if u wanna do it that way you gotta connect the WAN port to the upstream router (assuming this is a 2012 airport, else theres only one port so use that one) Also, the fact that it is in bridge means the linksys gives out the IP addresses, allowing for faster roaming (theoretically, have not done testing in the middle of a transfer) I got mine working, Airport express connected via ethernet to linksys router, both running their own WiFi networks with the same SSID's and passwords, allowing devices to roam between them. The network mode needs to be "Create a wireless network," it should Connect Using "Ethernet," and Connection Sharing needs to be "Off (Bridge mode)." Next, when setting up the Express, just set up its Network name and Password exactly the same as the network used by your non-Apple router. Make sure that the main non-Apple router is set to share a public IP address. The newer Airport Express models (the ones compatible with 802.11n) can do this.įirst, you need the Express connected to Ethernet. Otherwise, you can setup a roaming network. However, this is only if your AirPort Express is not connected to Ethernet. Mere minutes away from long-range Wi-Fi enjoyment. Launch theĮasy-to-use AirPort Utility app on your iOS device or Mac, and you’re Near the area where you want your wireless connection. an AirPort Extreme, Time Capsule, or another AirPort Express - and Just place it in range of your primary base station Wireless network in your home and want to extend its range, AirPortĮxpress can help. Apple seems to be saying in a round-a-bout way here that other routers are not supported for wireless range extensions (with a router connected to Ethernet and the Express not): Extend an existing Wi-Fi network’s range.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |